View Notes - Rescue.asd from COMM 2006 at University of the Philippines Diliman. Lab 11.6.2: Challenge OSPF Configuration Lab Device Default Gateway Subnet. Lab 11.6.2: Challenge OSPF Configuration Lab (Instructor Version) Topology Diagram Addressing Table Device HQ Branch1 Branch2 PC1 PC2 PC3 Interface IP Address Subnet Mask Default Gateway Fa0/0. . Perform basic configuration of the BRANCH, HQ, and ISP routers according to the following guidelines: 1. Jul 8, 2008 . 11.6.1 Basic OSPF Configuration Lab. New. 11.6.2 Challenge OSPF Configuration Lab. New. 11.6.3 Troubleshooting OSPF Configuration Lab. New. Routing Protocols and Concepts Summary of Skills and. Equipments Changes. There are new skills as well as new equipment being introduced in the CCNA . Learning Objectives. Upon completion of this lab, you will be able to: Cable a network according to the Topology Diagram. Erase the startup configuration and reload a router to the default state. Perform basic configuration tasks on a router. Configure and activate interfaces. Configure OSPF routing on all routers. Configure . Configure the Ethernet interfaces of PC1, PC2, and PC3 with the IP addresses and default gateways from the table under the Topology Diagram. Task: Configure OSPF on the R1 Router. Step 1: Use the router ospf command in global configuration mode to enable OSPF on the. R1 router. Enter a process ID of 1 for the . NDG has worked closely with the Cisco CCNA lab team to develop CCNA Exploration labs that are compatible with several NETLAB+ router pods. CCNA Exploration 2 is supported by one or. . 11.6.2, Challenge OSPF Configuration Lab, MAP, MAP w/ASA, CRP or BRPv2. 11.6.3, OSPF Troubleshooting Lab, MAP, MAP . Lab 2.5.1: Basic PPP Configuration Lab Lab 2.5.2: Challenge PPP Configuration Lab 2.5.3:. Lab 7.4.1: Basic DHCP and NAT Configuration Lab 7.4.2: Challenge DHCP and NAT Configuration Lab 7.4.3:. Lab 11.6.1: Basic OSPF Configuration Lab Lab 11.6.2: Challenge OSPF Configuration Lab Lab 11.6.3: OSPF . Chapter 11: OSPF. 533. Packet Tracer Companion. Packet Tracer Companion: Basic OSPF Configuration (11.6.1) You can now open the file LSG02-Lab1161b. pka on the CD-ROM that accompanies this book to. Lab 11-2: Challenge OSPF Configuration (11.6.2). Figure 11-13 Topology Diagram for Lab 11-2 (Answer)